What is difference between Dwell time and Hop time in LoRaWAN, LoRa
This page describes dwell time and hop time in LoRaWAN or LoRa.
Introduction:
These terms are related to each other and they are explained below.
The terms are associated with chirp spread spectrum (CSS) modulation technique.
It uses wideband linear frequency modulated chirp pulses in order
to encode baseband information.
Chirp Spread Spectrum is used in space and military communications due to
its long range, low transmit power and less interference.
Dwell time
Dwell time (or transmit time) is the amount of time needed to transmit on a frequency.
Hop time
Hop time is the amount of time needed to change from one frequency to another in which the radio is not transmitting.
LoRaWAN related links
The LoRaWAN Wireless tutorial covers following sub topics:
LoRaWAN Smart Parking
LoRaWAN sensor design
LoRaWAN smart healthcare system
LoRaWAN smart water metering
LoRaWAN architecture
LoRaWAN Interface Types
LoRaWAN roaming types
LoRa tutorial
LoRa Frequency Bands
LoRa protocol stack
LoRa MAC layer
LoRaWAN classes
LoRa features
LoRa Transceiver module
IoT Wireless Technologies
➤WLAN ➤THREAD ➤EnOcean ➤LoRa ➤SIGFOX ➤WHDI ➤Zigbee ➤6LoWPAN ➤Zigbee RF4CE ➤Z-Wave ➤NFC ➤RFID ➤Lonworks ➤CEBus ➤UPB
What is difference between
Difference between OSI and TCPIP layers Difference between TCP UDP FTP vs HTTP FTP vs SMTP FTP vs TFTP ARP vs RARP NAT vs PAT RIP vs OSPF SLIP vs PPP IMAP4 vs POP3 IPV4 vs IPV6