Home of RF and Wireless Vendors and Resources

One Stop For Your RF and Wireless Need

VHDL code to control external lights using Relays

This page of VHDL source code section covers VHDL code to control external lights using Relays.

VHDL code to control external lights using Relays

library ieee;
use ieee.std_logic_1164.all;
use ieee.std_logic_unsigned.all;
library unisim;
use unisim.vcomponents.all;
entity light is
Port ( cntrl1,cntrl2 : in STD_LOGIC;
led : out STD_LOGIC);
end light;
architecture Behavioral of light is
begin
led<=cntrl1 or cntrl2;
end Behavioral;


USEFUL LINKS to VHDL CODES

Refer following as well as links mentioned on left side panel for useful VHDL codes.
D Flipflop
T Flipflop
Read Write RAM
4X1 MUX
4 bit binary counter
Radix4 Butterfly
16QAM Modulation
2bit Parallel to serial

USEFUL LINKS to Verilog Codes

Following are the links to useful Verilog codes.
Low Pass FIR Filter
Asynchronous FIFO design with verilog code
D FF without reset
D FF synchronous reset
1 bit 4 bit comparator
All Logic Gates

RF and Wireless tutorials

WLAN  802.11ac  802.11ad  wimax  Zigbee  z-wave  GSM  LTE  UMTS  Bluetooth  UWB  IoT  satellite  Antenna  RADAR 


Share this page

Translate this page